Our Wiring Centres & Receivers Supplies
The wireless receivers and wiring centres are connected to the boiler or underfloor heating depending on your heating system and the number of the temperature zones.
To find out more about the wiring please read the product's manual.
If you are not sure which product is the idel one for your heating system please contact us here.
-
Heatmiser Two Zone Wireless Receiver RC1-W
£45.00The RC1-W is a flush mount wireless thermostat receiver. It is capable of controlling 2 heating zones, using the PRT-W or 1 heating and hot water zone, using the PRT/HW-W.
Find Out More » -
Heatmiser Two Zone Wireless Receiver RC1-WTS
£50.76The RC1-WTS is a flush mount wireless thermostat receiver. It is capable of controlling 2 heating zones, by using PRT-WTS or 1 heating and hot water zone, by using the PRT/HW-WTS
Only suitable for the Heatmiser PRT-WTS or PRTHW-WTS.
Find Out More » -
Heatmiser 8 Zone Wired Wiring Centre UH3
£73.20Up to 8 zones can be controlled from the Heatmiser wired wiring centre. On board the UH3 are two heating time channels, each zone allows you to specify which time channel it should follow.
Find Out More » -
Heatmiser 8 Zone Wireless Wiring Centre UH1-W
£125.46The UH1-W provides central switching and is therefore ideally situated next to the underfloor heating manifold. 8 zones can be controlled as well as providing an output for a hot water cylinder.
Find Out More » -
Remote Sensor Probe MISC103
£6.30This sensor can be used to measure air and floor temperature. This probe is supplied with a 3 meter cable which can be extended to 20 meters if required.
Suitable for PRT-RP, PRT-W, PRT-ETS
Find Out More »






